PenangAPRS Track

My position About ☰

reset

SQ7AYZ-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ7AYZ-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1794351484	260 Count	259 Count	148 Count
1794349683	259 Count	259 Count	148 Count
1794347883	258 Count	259 Count	148 Count
1794346082	257 Count	259 Count	148 Count
1794344282	256 Count	259 Count	148 Count
1794342481	253 Count	257 Count	146 Count
1794340680	251 Count	256 Count	145 Count
1794338880	250 Count	256 Count	145 Count
1794337086	249 Count	256 Count	145 Count
1794335286	248 Count	256 Count	145 Count
1794333485	247 Count	256 Count	145 Count
1794331684	246 Count	256 Count	145 Count
1794329884	245 Count	256 Count	145 Count
1794328083	244 Count	256 Count	145 Count
1794326282	243 Count	256 Count	145 Count
1794324482	241 Count	255 Count	144 Count
1794322681	239 Count	254 Count	143 Count
1794320880	238 Count	254 Count	143 Count
1794319080	237 Count	254 Count	143 Count
1794317279	236 Count	254 Count	143 Count
1794315493	234 Count	253 Count	142 Count
1794313692	233 Count	253 Count	142 Count
1794311892	232 Count	253 Count	142 Count
1794310091	231 Count	253 Count	142 Count
1794308290	230 Count	253 Count	142 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)