PenangAPRS Track

My position About ☰

reset

IK1TTD-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object IK1TTD-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

Time	TX*	RX*	Digi*
1794339408	185 Count	415 Count	174 Count
1794335801	152 Count	336 Count	143 Count
1794332195	116 Count	271 Count	109 Count
1794328629	86 Count	214 Count	81 Count
1794325022	61 Count	155 Count	58 Count
1794321415	32 Count	79 Count	31 Count
1794317809	502 Count	1041 Count	466 Count
1794314202	476 Count	967 Count	442 Count
1794310596	449 Count	893 Count	417 Count
1794307022	425 Count	818 Count	395 Count
1794303415	399 Count	764 Count	371 Count
1794299808	370 Count	712 Count	344 Count
1794296202	342 Count	663 Count	318 Count
1794292595	314 Count	612 Count	292 Count
1794288989	284 Count	560 Count	264 Count
1794285421	258 Count	513 Count	240 Count
1794281814	231 Count	461 Count	215 Count
1794278207	203 Count	406 Count	189 Count
1794274601	177 Count	355 Count	165 Count
1794270994	151 Count	303 Count	141 Count
1794267388	124 Count	256 Count	116 Count
1794263824	96 Count	186 Count	90 Count
1794260217	65 Count	123 Count	61 Count
1794256611	37 Count	75 Count	35 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)