PenangAPRS Track

My position About ☰

reset

IZ5IOM-15 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object IZ5IOM-15. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1787746985	2 Count	57 Count
1787745182	1 Count	34 Count
1787743379	0 Count	0 Count
1787741615	36 Count	978 Count
1787739811	35 Count	941 Count
1787738008	34 Count	920 Count
1787736204	33 Count	888 Count
1787734401	32 Count	866 Count
1787732598	31 Count	843 Count
1787730794	30 Count	823 Count
1787728991	29 Count	803 Count
1787727187	28 Count	779 Count
1787725384	27 Count	742 Count
1787723581	26 Count	721 Count
1787721777	25 Count	698 Count
1787720014	24 Count	672 Count
1787718211	23 Count	643 Count
1787716407	22 Count	617 Count
1787714604	21 Count	596 Count
1787712800	20 Count	571 Count
1787710997	19 Count	545 Count
1787709194	18 Count	521 Count
1787707390	17 Count	499 Count
1787705587	16 Count	474 Count
1787703783	15 Count	452 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)