PenangAPRS Track

My position About ☰

reset

SP1WLQ-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP1WLQ-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1789998740	536 Count	35 Count	35 Count
1789998619	535 Count	35 Count	35 Count
1789998498	534 Count	35 Count	35 Count
1789998378	533 Count	35 Count	35 Count
1789998257	532 Count	35 Count	35 Count
1789998136	531 Count	35 Count	35 Count
1789998016	530 Count	35 Count	35 Count
1789997895	529 Count	35 Count	35 Count
1789997774	528 Count	35 Count	35 Count
1789997653	527 Count	35 Count	35 Count
1789997412	525 Count	35 Count	35 Count
1789997292	524 Count	35 Count	35 Count
1789997050	522 Count	35 Count	35 Count
1789996930	521 Count	35 Count	35 Count
1789996809	520 Count	35 Count	35 Count
1789996568	518 Count	35 Count	35 Count
1789996206	515 Count	35 Count	35 Count
1789996085	514 Count	35 Count	35 Count
1789995965	513 Count	35 Count	35 Count
1789995602	510 Count	35 Count	35 Count
1789995482	509 Count	35 Count	35 Count
1789995241	507 Count	35 Count	35 Count
1789994878	504 Count	35 Count	35 Count
1789994758	503 Count	35 Count	35 Count
1789994708	502 Count	35 Count	35 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)