PenangAPRS Track

My position About ☰

reset

KQ6DI-4 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object KQ6DI-4. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	DC*	PC Board*	Ambient*	upper*	lower*
1764974164	239	748	686	537	519
1764972367	242	754	690	543	525
1764970564	239	749	687	536	519
1764968767	245	754	692	542	525
1764966964	239	751	689	528	516
1764965168	240	745	687	521	506
1764963364	240	754	691	522	507
1764961568	245	749	687	507	496
1764959765	245	750	688	515	497
1764957969	239	753	688	503	496
1764956164	239	749	684	497	485
1764954366	239	746	681	490	481
1764952564	239	744	678	484	476
1764950767	239	742	672	480	470
1764948965	239	731	664	467	460
1764947168	242	713	652	444	440
1764945364	242	716	654	442	439
1764943566	245	719	663	449	442
1764941764	242	715	653	427	427
1764939967	240	718	656	428	425
1764938166	245	713	652	412	413
1764936367	240	717	654	413	412
1764934565	240	718	663	425	417
1764932768	242	713	653	402	402
1764930965	245	715	655	399	400

*Used Equation Coefficients:

DC: 0, 1, 0

PC Board: 0, 1, 0

Ambient: 0, 1, 0

upper: 0, 1, 0

lower: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)