PenangAPRS Track

My position About ☰

reset

DJ1FC-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object DJ1FC-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

Time	TX*	RX*
1790319095	91 Count	419 Count
1790315487	89 Count	405 Count
1790311879	87 Count	389 Count
1790308271	85 Count	369 Count
1790304663	83 Count	334 Count
1790301055	81 Count	324 Count
1790297592	79 Count	318 Count
1790293984	77 Count	312 Count
1790290375	75 Count	307 Count
1790286767	73 Count	302 Count
1790283159	71 Count	295 Count
1790279551	69 Count	287 Count
1790275943	67 Count	280 Count
1790272335	65 Count	271 Count
1790268727	63 Count	268 Count
1790265119	61 Count	263 Count
1790261511	59 Count	258 Count
1790257902	57 Count	247 Count
1790254294	55 Count	213 Count
1790250686	53 Count	186 Count
1790247078	51 Count	182 Count
1790243470	49 Count	173 Count
1790239862	47 Count	167 Count
1790236254	45 Count	162 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)