PenangAPRS Track

My position About ☰

reset

DL0PCN-14 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object DL0PCN-14. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1783052468	2899	1298	79	957	931
1783052311	2810	1129	86	908	931
1783052276	2829	1083	138	925	930
1783052123	2606	1127	94	937	931
1783051936	3645	1516	76	904	929
1783051917	2701	1083	88	943	929
1783051500	2942	1257	81	896	929
1783051342	3838	1725	73	872	927
1783051323	3220	1492	19	917	929
1783051146	3220	1492	99	917	929
1783051125	4176	1845	141	931	929
1783050982	3528	1440	19	870	930
1783050835	3528	1440	69	870	930
1783050817	2928	706	93	974	929
1783050740	2928	706	101	974	929
1783050602	2689	1247	125	864	928
1783050539	3352	1162	19	907	930
1783050356	3352	1162	71	907	930
1783050336	2865	701	80	970	931
1783050262	2865	701	95	970	931
1783050159	3315	1528	95	855	929
1783050095	2751	1224	109	878	931
1783049769	2828	1114	65	883	929
1783049750	2601	660	130	898	934
1783049472	2735	1237	60	853	935

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)