PenangAPRS Track

My position About ☰

reset

DA6CH-12 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object DA6CH-12. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1782578842	64 Count	154 Count
1782577039	63 Count	153 Count
1782575235	62 Count	153 Count
1782573432	61 Count	153 Count
1782571629	60 Count	149 Count
1782569826	59 Count	148 Count
1782568023	58 Count	147 Count
1782566220	57 Count	147 Count
1782564454	56 Count	147 Count
1782562651	55 Count	146 Count
1782560848	54 Count	146 Count
1782559044	53 Count	146 Count
1782557241	52 Count	146 Count
1782555438	51 Count	133 Count
1782553634	50 Count	132 Count
1782551831	49 Count	129 Count
1782550028	48 Count	120 Count
1782548225	47 Count	120 Count
1782546422	46 Count	120 Count
1782544619	45 Count	106 Count
1782542853	44 Count	106 Count
1782541050	43 Count	105 Count
1782539247	42 Count	104 Count
1782537444	41 Count	100 Count
1782535641	40 Count	97 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)