PenangAPRS Track

My position About ☰

reset

F6KNH-14 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object F6KNH-14. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1782646494	219 Count	106 Count	87 Count
1782644690	218 Count	106 Count	87 Count
1782642886	217 Count	106 Count	87 Count
1782641124	212 Count	105 Count	87 Count
1782639320	211 Count	105 Count	87 Count
1782637516	210 Count	105 Count	87 Count
1782633909	208 Count	105 Count	87 Count
1782632105	207 Count	105 Count	87 Count
1782628498	205 Count	105 Count	87 Count
1782624890	203 Count	105 Count	87 Count
1782623087	202 Count	105 Count	87 Count
1782621283	201 Count	105 Count	87 Count
1782619521	196 Count	105 Count	87 Count
1782614110	193 Count	105 Count	87 Count
1782612305	192 Count	105 Count	87 Count
1782608698	190 Count	105 Count	87 Count
1782606894	189 Count	105 Count	87 Count
1782605091	188 Count	105 Count	87 Count
1782603287	186 Count	104 Count	86 Count
1782601483	185 Count	104 Count	86 Count
1782599679	184 Count	104 Count	86 Count
1782597917	179 Count	104 Count	86 Count
1782596114	176 Count	102 Count	84 Count
1782592506	170 Count	98 Count	80 Count
1782590702	167 Count	96 Count	78 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)