PenangAPRS Track

My position About ☰

reset

G0DUB-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object G0DUB-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1786415729	11 Count	331 Count
1786413926	10 Count	303 Count
1786412123	9 Count	282 Count
1786410320	8 Count	255 Count
1786408554	7 Count	230 Count
1786406750	6 Count	199 Count
1786404947	5 Count	173 Count
1786403144	4 Count	145 Count
1786401341	3 Count	113 Count
1786399538	2 Count	83 Count
1786397735	1 Count	53 Count
1786395932	0 Count	26 Count
1786394129	39 Count	1021 Count
1786392326	38 Count	997 Count
1786390523	37 Count	971 Count
1786386953	35 Count	920 Count
1786385150	34 Count	898 Count
1786383347	33 Count	875 Count
1786381544	32 Count	853 Count
1786379741	31 Count	832 Count
1786377938	30 Count	805 Count
1786376135	29 Count	783 Count
1786374332	28 Count	755 Count
1786372529	27 Count	712 Count
1786370726	26 Count	685 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)