PenangAPRS Track

My position About ☰

reset

DG1MJG-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object DG1MJG-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*
1786409986	943 Count	645 Count
1786409505	942 Count	645 Count
1786408901	941 Count	644 Count
1786408298	940 Count	642 Count
1786407695	939 Count	642 Count
1786407092	938 Count	640 Count
1786406489	937 Count	640 Count
1786405885	936 Count	639 Count
1786405281	935 Count	637 Count
1786404678	934 Count	635 Count
1786404075	933 Count	634 Count
1786403472	932 Count	634 Count
1786402868	931 Count	634 Count
1786402265	930 Count	632 Count
1786401662	929 Count	629 Count
1786401059	928 Count	627 Count
1786400456	927 Count	627 Count
1786399852	926 Count	627 Count
1786399249	925 Count	626 Count
1786398646	924 Count	626 Count
1786398043	923 Count	624 Count
1786397439	922 Count	624 Count
1786396836	921 Count	624 Count
1786396233	920 Count	624 Count
1786395630	919 Count	624 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)