PenangAPRS Track

My position About ☰

reset

SQ9WRT-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ9WRT-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 >>

Time	TX*	RX*	Digi*
1781865775	85 Count	872 Count	47 Count
1781864874	83 Count	852 Count	46 Count
1781863974	81 Count	830 Count	45 Count
1781860397	69 Count	754 Count	41 Count
1781859494	67 Count	740 Count	40 Count
1781858593	64 Count	722 Count	38 Count
1781857693	62 Count	700 Count	37 Count
1781856791	60 Count	678 Count	36 Count
1781855891	58 Count	657 Count	35 Count
1781854992	56 Count	623 Count	34 Count
1781854089	54 Count	599 Count	33 Count
1781853191	52 Count	574 Count	32 Count
1781851386	48 Count	517 Count	30 Count
1781849579	41 Count	460 Count	25 Count
1781847778	28 Count	381 Count	14 Count
1781845975	24 Count	315 Count	12 Count
1781844174	21 Count	238 Count	11 Count
1781842371	17 Count	158 Count	9 Count
1781840571	12 Count	103 Count	6 Count
1781835196	136 Count	960 Count	77 Count
1781834296	134 Count	944 Count	76 Count
1781832495	130 Count	898 Count	74 Count
1781830692	126 Count	860 Count	72 Count
1781826187	116 Count	759 Count	67 Count
1781824384	112 Count	713 Count	65 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)