PenangAPRS Track

My position About ☰

reset

LU7FDV-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object LU7FDV-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 >>

Time	TX*	RX*	Digi*
1781920086	328 Count	276 Count	144 Count
1781919183	327 Count	276 Count	144 Count
1781918280	326 Count	276 Count	144 Count
1781917377	325 Count	276 Count	144 Count
1781916474	324 Count	276 Count	144 Count
1781915570	323 Count	276 Count	144 Count
1781914667	322 Count	276 Count	144 Count
1781913764	321 Count	276 Count	144 Count
1781912861	320 Count	276 Count	144 Count
1781911958	318 Count	275 Count	143 Count
1781911055	316 Count	274 Count	142 Count
1781910151	311 Count	270 Count	138 Count
1781909248	304 Count	264 Count	132 Count
1781908345	302 Count	263 Count	131 Count
1781907442	300 Count	262 Count	130 Count
1781906538	292 Count	255 Count	123 Count
1781905710	286 Count	254 Count	122 Count
1781904807	284 Count	253 Count	121 Count
1781903903	282 Count	252 Count	120 Count
1781903000	280 Count	251 Count	119 Count
1781902097	278 Count	250 Count	118 Count
1781901194	274 Count	247 Count	115 Count
1781900291	271 Count	245 Count	113 Count
1781899387	270 Count	245 Count	113 Count
1781898484	269 Count	245 Count	113 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)