PenangAPRS Track

My position About ☰

reset

SV3GCB-12 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SV3GCB-12. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1786577210	191 Count	184 Count	92 Count
1786576605	189 Count	182 Count	91 Count
1786576001	187 Count	180 Count	90 Count
1786575396	185 Count	178 Count	89 Count
1786574792	183 Count	176 Count	88 Count
1786574187	181 Count	174 Count	87 Count
1786573583	179 Count	172 Count	86 Count
1786572978	177 Count	170 Count	85 Count
1786572374	175 Count	168 Count	84 Count
1786571769	173 Count	166 Count	83 Count
1786571165	171 Count	164 Count	82 Count
1786570560	169 Count	162 Count	81 Count
1786569956	167 Count	160 Count	80 Count
1786569353	165 Count	158 Count	79 Count
1786568747	163 Count	156 Count	78 Count
1786568142	161 Count	154 Count	77 Count
1786567538	159 Count	152 Count	76 Count
1786566933	157 Count	150 Count	75 Count
1786566330	155 Count	148 Count	74 Count
1786565724	153 Count	146 Count	73 Count
1786565120	151 Count	144 Count	72 Count
1786564515	149 Count	142 Count	71 Count
1786563911	147 Count	140 Count	70 Count
1786563306	145 Count	138 Count	69 Count
1786562702	143 Count	136 Count	68 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)