PenangAPRS Track

My position About ☰

reset

OE4EXE-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object OE4EXE-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*
1783229287	12 Count	306 Count
1783228683	11 Count	279 Count
1783228080	10 Count	246 Count
1783227477	9 Count	214 Count
1783226874	8 Count	187 Count
1783226271	7 Count	158 Count
1783225667	6 Count	129 Count
1783225064	5 Count	110 Count
1783224460	4 Count	90 Count
1783223857	3 Count	76 Count
1783223254	2 Count	67 Count
1783222651	1 Count	49 Count
1783222047	0 Count	30 Count
1783221443	32 Count	1010 Count
1783220840	31 Count	941 Count
1783220237	30 Count	876 Count
1783219634	29 Count	841 Count
1783219031	28 Count	809 Count
1783218427	27 Count	775 Count
1783217824	26 Count	751 Count
1783217221	25 Count	729 Count
1783216617	24 Count	698 Count
1783216014	23 Count	680 Count
1783215411	22 Count	671 Count
1783214808	21 Count	658 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)