PenangAPRS Track

My position About ☰

reset

DL1KDA-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object DL1KDA-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1781330831	441 Count	942 Count	372 Count
1781329027	439 Count	941 Count	371 Count
1781327223	437 Count	940 Count	370 Count
1781325419	436 Count	939 Count	370 Count
1781323615	431 Count	935 Count	366 Count
1781321811	427 Count	925 Count	363 Count
1781320006	419 Count	909 Count	356 Count
1781318203	413 Count	895 Count	351 Count
1781316453	406 Count	881 Count	345 Count
1781314653	400 Count	865 Count	340 Count
1781312842	393 Count	850 Count	334 Count
1781311036	389 Count	837 Count	331 Count
1781309231	381 Count	820 Count	324 Count
1781307427	375 Count	806 Count	319 Count
1781306469	369 Count	791 Count	314 Count
1781306469	368 Count	790 Count	314 Count
1781305623	369 Count	791 Count	314 Count
1781303820	368 Count	790 Count	314 Count
1781302015	360 Count	773 Count	307 Count
1781300210	357 Count	765 Count	305 Count
1781298409	350 Count	749 Count	299 Count
1781296602	343 Count	734 Count	293 Count
1781294848	335 Count	717 Count	286 Count
1781293045	334 Count	716 Count	286 Count
1781291239	333 Count	716 Count	286 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)