PenangAPRS Track

My position About ☰

reset

EA7HQG-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object EA7HQG-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1780213302	26 Count	212 Count	21 Count
1780211499	23 Count	179 Count	19 Count
1780209696	20 Count	151 Count	17 Count
1780207893	15 Count	119 Count	13 Count
1780206089	9 Count	83 Count	8 Count
1780204286	4 Count	46 Count	4 Count
1780202520	254 Count	1005 Count	195 Count
1780200717	250 Count	978 Count	192 Count
1780198914	244 Count	959 Count	187 Count
1780197111	240 Count	946 Count	184 Count
1780195307	235 Count	931 Count	180 Count
1780193504	227 Count	910 Count	173 Count
1780191701	222 Count	890 Count	169 Count
1780189898	218 Count	870 Count	166 Count
1780188095	213 Count	846 Count	162 Count
1780186292	208 Count	825 Count	158 Count
1780184488	202 Count	804 Count	153 Count
1780182685	197 Count	776 Count	149 Count
1780180919	192 Count	750 Count	145 Count
1780179116	187 Count	726 Count	141 Count
1780177313	182 Count	706 Count	137 Count
1780175510	177 Count	681 Count	133 Count
1780173707	173 Count	661 Count	130 Count
1780171904	168 Count	643 Count	126 Count
1780170100	163 Count	623 Count	122 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)