PenangAPRS Track

My position About ☰

reset

PE1PMD-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object PE1PMD-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1790337154	310 Count	813 Count	238 Count
1790336250	307 Count	805 Count	236 Count
1790335346	303 Count	795 Count	233 Count
1790334442	299 Count	784 Count	230 Count
1790333539	297 Count	776 Count	229 Count
1790332635	295 Count	770 Count	228 Count
1790331732	292 Count	761 Count	226 Count
1790330828	289 Count	752 Count	224 Count
1790329925	287 Count	743 Count	223 Count
1790329021	284 Count	735 Count	221 Count
1790328119	281 Count	729 Count	219 Count
1790327217	277 Count	719 Count	216 Count
1790326310	271 Count	708 Count	212 Count
1790325406	269 Count	700 Count	211 Count
1790324502	266 Count	690 Count	209 Count
1790323599	262 Count	683 Count	206 Count
1790322695	258 Count	670 Count	203 Count
1790321792	255 Count	660 Count	201 Count
1790320979	251 Count	647 Count	198 Count
1790320074	246 Count	638 Count	195 Count
1790319171	240 Count	629 Count	190 Count
1790318270	237 Count	622 Count	188 Count
1790317364	233 Count	612 Count	185 Count
1790316460	229 Count	602 Count	182 Count
1790315557	226 Count	594 Count	180 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)