PenangAPRS Track

My position About ☰

reset

F4MLV-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object F4MLV-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1780176648	415 Count	637 Count	350 Count
1780174844	376 Count	563 Count	318 Count
1780173040	328 Count	487 Count	277 Count
1780171236	281 Count	408 Count	237 Count
1780169433	230 Count	334 Count	194 Count
1780167629	178 Count	253 Count	150 Count
1780165825	131 Count	182 Count	110 Count
1780164021	87 Count	118 Count	74 Count
1780162218	36 Count	61 Count	30 Count
1780160414	673 Count	1022 Count	576 Count
1780158610	636 Count	957 Count	548 Count
1780156806	600 Count	880 Count	520 Count
1780156790	599 Count	880 Count	520 Count
1780155365	598 Count	880 Count	520 Count
1780153560	551 Count	807 Count	480 Count
1780151756	506 Count	742 Count	443 Count
1780149952	457 Count	666 Count	401 Count
1780148149	402 Count	584 Count	353 Count
1780146345	337 Count	496 Count	295 Count
1780144540	280 Count	410 Count	245 Count
1780142737	221 Count	318 Count	193 Count
1780140933	164 Count	234 Count	143 Count
1780139128	103 Count	156 Count	90 Count
1780137401	57 Count	85 Count	51 Count
1780135598	619 Count	1006 Count	493 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)