PenangAPRS Track

My position About ☰

reset

SR8RZE-3 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SR8RZE-3. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1786416293	184 Count	656 Count	176 Count
1786415392	178 Count	621 Count	171 Count
1786414491	175 Count	576 Count	169 Count
1786413590	171 Count	535 Count	166 Count
1786412690	168 Count	485 Count	164 Count
1786411789	162 Count	419 Count	159 Count
1786410889	146 Count	350 Count	144 Count
1786409988	143 Count	316 Count	142 Count
1786409087	77 Count	159 Count	77 Count
1786408186	187 Count	1039 Count	162 Count
1786405484	96 Count	779 Count	74 Count
1786404583	93 Count	738 Count	72 Count
1786403683	90 Count	706 Count	70 Count
1786402782	87 Count	666 Count	68 Count
1786401897	79 Count	620 Count	65 Count
1786400996	76 Count	565 Count	63 Count
1786400096	73 Count	536 Count	61 Count
1786399195	70 Count	501 Count	59 Count
1786398294	59 Count	461 Count	49 Count
1786397394	56 Count	424 Count	47 Count
1786396493	53 Count	390 Count	45 Count
1786395592	50 Count	360 Count	43 Count
1786394691	46 Count	326 Count	40 Count
1786393791	43 Count	297 Count	38 Count
1786392890	40 Count	264 Count	36 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)