PenangAPRS Track

My position About ☰

reset

IU5RCJ-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object IU5RCJ-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1780190273	770 Count	544 Count	123 Count
1780189370	757 Count	536 Count	120 Count
1780188466	744 Count	526 Count	118 Count
1780187563	731 Count	510 Count	115 Count
1780186659	719 Count	504 Count	113 Count
1780185756	706 Count	496 Count	110 Count
1780184852	693 Count	487 Count	108 Count
1780183948	675 Count	477 Count	104 Count
1780183044	663 Count	470 Count	102 Count
1780182140	646 Count	464 Count	99 Count
1780181233	632 Count	457 Count	95 Count
1780180330	618 Count	451 Count	93 Count
1780179426	608 Count	445 Count	92 Count
1780178523	593 Count	439 Count	89 Count
1780177615	584 Count	429 Count	89 Count
1780176712	570 Count	421 Count	88 Count
1780175808	561 Count	411 Count	87 Count
1780174905	543 Count	405 Count	84 Count
1780174001	532 Count	398 Count	81 Count
1780173183	516 Count	390 Count	76 Count
1780172280	501 Count	383 Count	73 Count
1780171376	487 Count	378 Count	70 Count
1780170473	472 Count	372 Count	67 Count
1780169569	458 Count	363 Count	64 Count
1780168666	445 Count	342 Count	62 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)