PenangAPRS Track

My position About ☰

reset

M9NSZ-11 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object M9NSZ-11. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1794351214	79 Count	216 Count
1794349411	78 Count	216 Count
1794347607	77 Count	216 Count
1794345804	76 Count	216 Count
1794344001	75 Count	216 Count
1794342198	74 Count	216 Count
1794340395	73 Count	216 Count
1794338592	72 Count	216 Count
1794336825	71 Count	216 Count
1794335022	70 Count	216 Count
1794333219	69 Count	216 Count
1794331416	68 Count	216 Count
1794329613	67 Count	216 Count
1794327809	66 Count	212 Count
1794326006	65 Count	201 Count
1794324203	64 Count	196 Count
1794322400	63 Count	176 Count
1794320597	62 Count	172 Count
1794318794	61 Count	170 Count
1794316991	60 Count	169 Count
1794315225	59 Count	166 Count
1794313422	58 Count	166 Count
1794311619	57 Count	165 Count
1794309816	56 Count	162 Count
1794308013	55 Count	158 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)