PenangAPRS Track

My position About ☰

reset

F5ZMX-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object F5ZMX-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1794358323	261 Count	823 Count	118 Count
1794357502	256 Count	818 Count	118 Count
1794356599	240 Count	813 Count	118 Count
1794355695	210 Count	803 Count	118 Count
1794354792	208 Count	798 Count	117 Count
1794353889	207 Count	792 Count	117 Count
1794352985	205 Count	784 Count	116 Count
1794352082	204 Count	779 Count	116 Count
1794351178	202 Count	772 Count	115 Count
1794350275	201 Count	766 Count	115 Count
1794349371	198 Count	760 Count	113 Count
1794348468	197 Count	756 Count	113 Count
1794347565	194 Count	746 Count	111 Count
1794346661	193 Count	739 Count	111 Count
1794345758	191 Count	730 Count	110 Count
1794344855	190 Count	720 Count	110 Count
1794343951	188 Count	711 Count	109 Count
1794343048	187 Count	703 Count	109 Count
1794342145	185 Count	693 Count	108 Count
1794341241	184 Count	688 Count	108 Count
1794340337	166 Count	658 Count	100 Count
1794339434	159 Count	640 Count	97 Count
1794338530	157 Count	629 Count	96 Count
1794337627	155 Count	620 Count	95 Count
1794336724	143 Count	595 Count	84 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)