PenangAPRS Track

My position About ☰

reset

SQ9IKM-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ9IKM-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1780215957	40 Count	245 Count	27 Count
1780215057	38 Count	234 Count	26 Count
1780214156	35 Count	223 Count	24 Count
1780213255	32 Count	201 Count	22 Count
1780212355	30 Count	171 Count	21 Count
1780211454	29 Count	171 Count	21 Count
1780211179	28 Count	171 Count	21 Count
1780210278	26 Count	164 Count	20 Count
1780209378	22 Count	153 Count	17 Count
1780208477	15 Count	120 Count	11 Count
1780207592	12 Count	101 Count	9 Count
1780206691	9 Count	85 Count	7 Count
1780205791	7 Count	64 Count	6 Count
1780204890	3 Count	26 Count	3 Count
1780203989	156 Count	1001 Count	118 Count
1780203089	151 Count	988 Count	114 Count
1780202188	148 Count	975 Count	112 Count
1780201287	142 Count	954 Count	107 Count
1780200387	140 Count	930 Count	106 Count
1780199486	138 Count	917 Count	105 Count
1780198585	135 Count	893 Count	103 Count
1780197685	133 Count	888 Count	102 Count
1780196784	129 Count	865 Count	99 Count
1780195884	125 Count	841 Count	96 Count
1780194983	120 Count	819 Count	92 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)