PenangAPRS Track

My position About ☰

reset

SP6TPX-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP6TPX-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1780212367	21 Count	437 Count	2 Count
1780210566	20 Count	412 Count	2 Count
1780208765	19 Count	377 Count	2 Count
1780206964	16 Count	344 Count	0 Count
1780205163	15 Count	327 Count	0 Count
1780203373	14 Count	300 Count	0 Count
1780201572	13 Count	266 Count	0 Count
1780199771	12 Count	246 Count	0 Count
1780197970	11 Count	227 Count	0 Count
1780196169	10 Count	207 Count	0 Count
1780194368	9 Count	193 Count	0 Count
1780192567	8 Count	179 Count	0 Count
1780190766	7 Count	169 Count	0 Count
1780188965	6 Count	150 Count	0 Count
1780187164	5 Count	131 Count	0 Count
1780185363	4 Count	110 Count	0 Count
1780183562	3 Count	90 Count	0 Count
1780181772	2 Count	64 Count	0 Count
1780179971	1 Count	41 Count	0 Count
1780178170	0 Count	21 Count	0 Count
1780176369	42 Count	1001 Count	13 Count
1780174568	41 Count	977 Count	13 Count
1780172767	40 Count	944 Count	13 Count
1780170966	39 Count	917 Count	13 Count
1780169165	38 Count	898 Count	13 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)