PenangAPRS Track

My position About ☰

reset

F5ZZW-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object F5ZZW-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1790004772	444 Count	630 Count	237 Count
1790004165	443 Count	629 Count	237 Count
1790003559	440 Count	626 Count	235 Count
1790002953	437 Count	622 Count	233 Count
1790002570	436 Count	620 Count	233 Count
1790001963	433 Count	599 Count	231 Count
1790001357	432 Count	598 Count	231 Count
1790000751	429 Count	595 Count	229 Count
1790000145	426 Count	593 Count	227 Count
1789999539	425 Count	591 Count	227 Count
1789998932	422 Count	587 Count	225 Count
1789998326	419 Count	584 Count	223 Count
1789997720	418 Count	583 Count	223 Count
1789997114	415 Count	580 Count	221 Count
1789996507	412 Count	578 Count	219 Count
1789995901	411 Count	577 Count	219 Count
1789995295	408 Count	568 Count	217 Count
1789994689	405 Count	564 Count	215 Count
1789994083	404 Count	563 Count	215 Count
1789993477	401 Count	560 Count	213 Count
1789992870	398 Count	558 Count	211 Count
1789992264	397 Count	557 Count	211 Count
1789991657	394 Count	545 Count	209 Count
1789991051	391 Count	537 Count	207 Count
1789990445	387 Count	532 Count	207 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)