PenangAPRS Track

My position About ☰

reset

F1MCO-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object F1MCO-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1773282111	77 Count	915 Count
1773280307	76 Count	897 Count
1773278503	75 Count	879 Count
1773276699	74 Count	859 Count
1773274939	69 Count	842 Count
1773273135	68 Count	822 Count
1773271331	67 Count	803 Count
1773269527	66 Count	783 Count
1773267723	65 Count	767 Count
1773262313	62 Count	724 Count
1773260508	61 Count	711 Count
1773258707	60 Count	693 Count
1773256900	59 Count	679 Count
1773255096	58 Count	659 Count
1773253336	53 Count	643 Count
1773251533	52 Count	627 Count
1773249728	45 Count	598 Count
1773247924	44 Count	577 Count
1773246121	43 Count	558 Count
1773244316	42 Count	539 Count
1773240709	40 Count	494 Count
1773238905	39 Count	469 Count
1773228125	29 Count	379 Count
1773226321	28 Count	365 Count
1773224517	27 Count	350 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)