PenangAPRS Track

My position About ☰

reset

SP6PTT Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP6PTT. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1794359245	77 Count	561 Count	70 Count
1794357445	53 Count	401 Count	47 Count
1794355644	30 Count	203 Count	25 Count
1794353852	189 Count	1134 Count	161 Count
1794352051	166 Count	973 Count	142 Count
1794350250	136 Count	822 Count	116 Count
1794348450	106 Count	662 Count	91 Count
1794346649	88 Count	561 Count	77 Count
1794344848	64 Count	441 Count	58 Count
1794343047	41 Count	267 Count	39 Count
1794341247	14 Count	106 Count	14 Count
1794339446	153 Count	1164 Count	147 Count
1794337645	132 Count	967 Count	127 Count
1794335844	128 Count	933 Count	124 Count
1794334044	107 Count	782 Count	104 Count
1794332251	76 Count	550 Count	75 Count
1794330450	38 Count	284 Count	38 Count
1794328649	98 Count	1097 Count	95 Count
1794326848	65 Count	830 Count	63 Count
1794325048	46 Count	550 Count	45 Count
1794323247	25 Count	311 Count	25 Count
1794321446	183 Count	1179 Count	178 Count
1794319646	161 Count	966 Count	157 Count
1794317845	120 Count	713 Count	117 Count
1794316044	84 Count	476 Count	82 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)