PenangAPRS Track

My position About ☰

reset

SP3NGH-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP3NGH-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1771625324	831 Count	381 Count	29 Count
1771623523	827 Count	381 Count	29 Count
1771621722	823 Count	381 Count	29 Count
1771619921	819 Count	381 Count	29 Count
1771618120	817 Count	381 Count	29 Count
1771616319	812 Count	381 Count	29 Count
1771614518	808 Count	381 Count	29 Count
1771612717	804 Count	381 Count	29 Count
1771610915	800 Count	381 Count	29 Count
1771609114	796 Count	381 Count	29 Count
1771607313	792 Count	381 Count	29 Count
1771605537	788 Count	381 Count	29 Count
1771603736	784 Count	381 Count	29 Count
1771601935	780 Count	381 Count	29 Count
1771600134	772 Count	381 Count	29 Count
1771598333	766 Count	381 Count	29 Count
1771596532	762 Count	381 Count	29 Count
1771594731	758 Count	358 Count	29 Count
1771592930	754 Count	315 Count	29 Count
1771591130	750 Count	295 Count	29 Count
1771589327	741 Count	266 Count	29 Count
1771587526	736 Count	222 Count	29 Count
1771585725	730 Count	176 Count	29 Count
1771583923	719 Count	133 Count	29 Count
1771582122	715 Count	133 Count	29 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)