PenangAPRS Track

My position About ☰

reset

LU2EQD-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object LU2EQD-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1771625454	197 Count	515 Count
1771623653	196 Count	509 Count
1771621852	195 Count	509 Count
1771620060	194 Count	509 Count
1771618259	193 Count	509 Count
1771616458	192 Count	504 Count
1771614657	191 Count	491 Count
1771612856	190 Count	476 Count
1771611056	189 Count	452 Count
1771609255	188 Count	441 Count
1771607454	187 Count	423 Count
1771605654	186 Count	414 Count
1771603853	185 Count	406 Count
1771602052	184 Count	399 Count
1771600251	183 Count	391 Count
1771598461	182 Count	391 Count
1771596659	181 Count	391 Count
1771594859	180 Count	391 Count
1771593057	179 Count	390 Count
1771591257	178 Count	390 Count
1771589456	177 Count	390 Count
1771587655	176 Count	390 Count
1771585853	175 Count	390 Count
1771584053	174 Count	390 Count
1771582251	173 Count	390 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)