PenangAPRS Track

My position About ☰

reset

HB9EZW-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object HB9EZW-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1773790869	408 Count	891 Count	123 Count
1773789966	407 Count	888 Count	123 Count
1773789063	406 Count	885 Count	123 Count
1773788160	404 Count	881 Count	122 Count
1773787257	402 Count	877 Count	121 Count
1773786354	400 Count	874 Count	120 Count
1773785451	399 Count	871 Count	120 Count
1773784548	397 Count	866 Count	119 Count
1773783645	395 Count	863 Count	118 Count
1773782742	394 Count	860 Count	118 Count
1773781838	393 Count	856 Count	118 Count
1773780935	392 Count	854 Count	118 Count
1773780032	390 Count	851 Count	117 Count
1773779129	389 Count	847 Count	117 Count
1773778226	388 Count	845 Count	117 Count
1773777323	386 Count	841 Count	116 Count
1773776493	384 Count	838 Count	115 Count
1773775590	382 Count	835 Count	114 Count
1773774687	381 Count	817 Count	114 Count
1773773784	380 Count	816 Count	114 Count
1773772881	378 Count	812 Count	113 Count
1773771977	377 Count	796 Count	113 Count
1773771074	376 Count	793 Count	113 Count
1773770171	375 Count	789 Count	113 Count
1773769268	374 Count	783 Count	113 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)