PenangAPRS Track

My position About ☰

reset

SP8PB-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP8PB-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1771462448	36 Count	57 Count	21 Count
1771461547	33 Count	52 Count	19 Count
1771460647	29 Count	47 Count	16 Count
1771459746	27 Count	44 Count	15 Count
1771458845	24 Count	38 Count	13 Count
1771457944	22 Count	34 Count	12 Count
1771457044	19 Count	29 Count	10 Count
1771456143	16 Count	24 Count	8 Count
1771455241	14 Count	21 Count	7 Count
1771454340	11 Count	16 Count	5 Count
1771453439	7 Count	8 Count	2 Count
1771452539	4 Count	0 Count	0 Count
1771451762	525 Count	1003 Count	378 Count
1771450861	521 Count	993 Count	375 Count
1771449961	514 Count	983 Count	369 Count
1771449060	510 Count	974 Count	366 Count
1771448159	507 Count	969 Count	364 Count
1771447259	505 Count	965 Count	363 Count
1771446358	502 Count	960 Count	361 Count
1771445457	499 Count	955 Count	359 Count
1771444556	496 Count	949 Count	357 Count
1771443656	493 Count	944 Count	355 Count
1771442755	489 Count	936 Count	352 Count
1771441854	486 Count	930 Count	350 Count
1771440953	482 Count	923 Count	347 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)