PenangAPRS Track

My position About ☰

reset

XE2AD-15 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object XE2AD-15. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1786429043	423 Count	410 Count	298 Count
1786427240	421 Count	409 Count	297 Count
1786425436	417 Count	406 Count	294 Count
1786423633	415 Count	405 Count	293 Count
1786421867	407 Count	401 Count	290 Count
1786420064	403 Count	396 Count	287 Count
1786418261	400 Count	393 Count	285 Count
1786416457	396 Count	389 Count	282 Count
1786414654	393 Count	386 Count	280 Count
1786412850	389 Count	383 Count	277 Count
1786411047	386 Count	380 Count	275 Count
1786409244	382 Count	377 Count	272 Count
1786407440	380 Count	376 Count	271 Count
1786405637	371 Count	367 Count	263 Count
1786403834	369 Count	365 Count	262 Count
1786402030	364 Count	360 Count	258 Count
1786400264	357 Count	357 Count	256 Count
1786398461	354 Count	340 Count	254 Count
1786396658	351 Count	335 Count	252 Count
1786394854	349 Count	328 Count	251 Count
1786393051	342 Count	317 Count	245 Count
1786391248	330 Count	300 Count	234 Count
1786389444	325 Count	293 Count	230 Count
1786387641	322 Count	291 Count	228 Count
1786385837	317 Count	286 Count	224 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)