PenangAPRS Track

My position About ☰

reset

SP3PSM-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP3PSM-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1786412267	7 Count	43 Count	7 Count
1786410466	106 Count	1043 Count	91 Count
1786408666	98 Count	994 Count	84 Count
1786406865	89 Count	946 Count	76 Count
1786405064	81 Count	895 Count	69 Count
1786403263	72 Count	852 Count	61 Count
1786401462	65 Count	804 Count	55 Count
1786399661	57 Count	762 Count	48 Count
1786397861	49 Count	718 Count	41 Count
1786396068	36 Count	676 Count	33 Count
1786394267	28 Count	549 Count	26 Count
1786392467	17 Count	391 Count	16 Count
1786390666	13 Count	228 Count	13 Count
1786388865	60 Count	1138 Count	49 Count
1786387064	50 Count	861 Count	40 Count
1786385264	42 Count	723 Count	33 Count
1786383463	35 Count	591 Count	27 Count
1786381662	29 Count	480 Count	22 Count
1786379861	24 Count	364 Count	18 Count
1786378060	19 Count	266 Count	14 Count
1786376260	12 Count	142 Count	8 Count
1786374467	62 Count	1010 Count	56 Count
1786372667	53 Count	742 Count	48 Count
1786370866	43 Count	462 Count	39 Count
1786369065	35 Count	318 Count	32 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)