PenangAPRS Track

My position About ☰

reset

F4GMT-12 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object F4GMT-12. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*
1790315617	133 Count	259 Count
1790314584	128 Count	257 Count
1790313683	127 Count	254 Count
1790312782	126 Count	252 Count
1790311882	125 Count	249 Count
1790310080	123 Count	244 Count
1790308278	121 Count	239 Count
1790307377	120 Count	237 Count
1790306477	119 Count	234 Count
1790305576	118 Count	232 Count
1790304675	117 Count	229 Count
1790303774	116 Count	227 Count
1790302874	115 Count	224 Count
1790301973	114 Count	222 Count
1790301072	113 Count	219 Count
1790300171	112 Count	217 Count
1790299271	111 Count	214 Count
1790298370	110 Count	212 Count
1790297470	109 Count	209 Count
1790296569	108 Count	207 Count
1790295668	107 Count	204 Count
1790294767	106 Count	202 Count
1790293866	105 Count	199 Count
1790292943	100 Count	198 Count
1790292043	99 Count	195 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)