PenangAPRS Track

My position About ☰

reset

LB3AG-11 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object LB3AG-11. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1790338788	593 Count	979 Count	435 Count
1790338185	590 Count	972 Count	433 Count
1790337582	583 Count	962 Count	427 Count
1790336979	570 Count	942 Count	415 Count
1790336376	565 Count	936 Count	413 Count
1790335771	561 Count	929 Count	410 Count
1790335168	557 Count	923 Count	407 Count
1790334565	556 Count	918 Count	407 Count
1790333962	552 Count	910 Count	404 Count
1790333359	549 Count	902 Count	402 Count
1790332756	547 Count	898 Count	401 Count
1790332152	544 Count	893 Count	399 Count
1790331550	540 Count	887 Count	396 Count
1790330946	539 Count	884 Count	396 Count
1790330343	535 Count	877 Count	393 Count
1790329740	532 Count	870 Count	391 Count
1790329137	530 Count	867 Count	390 Count
1790328534	526 Count	862 Count	387 Count
1790327931	523 Count	858 Count	385 Count
1790327328	521 Count	855 Count	384 Count
1790326725	518 Count	848 Count	382 Count
1790326122	515 Count	841 Count	380 Count
1790325519	512 Count	838 Count	379 Count
1790324916	509 Count	834 Count	377 Count
1790324312	505 Count	828 Count	374 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)