PenangAPRS Track

My position About ☰

reset

SQ9MJ-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ9MJ-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1790312731	37 Count	718 Count	0 Count
1790311830	36 Count	699 Count	0 Count
1790310929	34 Count	664 Count	0 Count
1790310028	31 Count	637 Count	0 Count
1790309131	29 Count	604 Count	0 Count
1790307324	27 Count	553 Count	0 Count
1790306423	26 Count	517 Count	0 Count
1790305523	23 Count	480 Count	0 Count
1790304622	22 Count	454 Count	0 Count
1790303744	21 Count	419 Count	0 Count
1790302843	20 Count	393 Count	0 Count
1790301941	17 Count	360 Count	0 Count
1790301040	16 Count	334 Count	0 Count
1790300139	15 Count	297 Count	0 Count
1790299238	14 Count	274 Count	0 Count
1790298337	12 Count	247 Count	0 Count
1790297436	10 Count	223 Count	0 Count
1790296535	9 Count	194 Count	0 Count
1790295634	8 Count	167 Count	0 Count
1790294733	6 Count	139 Count	0 Count
1790293832	4 Count	105 Count	0 Count
1790292931	3 Count	76 Count	0 Count
1790292030	2 Count	52 Count	0 Count
1790291129	0 Count	25 Count	0 Count
1790290228	91 Count	1027 Count	9 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)