PenangAPRS Track

My position About ☰

reset

MW0KEC-13 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object MW0KEC-13. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1770254935	61 Count	144 Count	37 Count
1770253169	60 Count	144 Count	37 Count
1770251366	59 Count	144 Count	37 Count
1770249563	58 Count	144 Count	37 Count
1770247759	57 Count	144 Count	37 Count
1770245956	56 Count	144 Count	37 Count
1770244153	55 Count	144 Count	37 Count
1770242350	54 Count	144 Count	37 Count
1770240547	53 Count	144 Count	37 Count
1770238744	52 Count	144 Count	37 Count
1770236940	51 Count	144 Count	37 Count
1770235137	50 Count	144 Count	37 Count
1770233334	49 Count	144 Count	37 Count
1770233184	48 Count	144 Count	37 Count
1770231381	43 Count	128 Count	33 Count
1770229577	37 Count	113 Count	28 Count
1770227774	32 Count	98 Count	24 Count
1770225971	28 Count	81 Count	21 Count
1770224168	23 Count	69 Count	17 Count
1770222365	19 Count	56 Count	14 Count
1770220561	16 Count	49 Count	12 Count
1770218758	14 Count	41 Count	11 Count
1770216992	10 Count	29 Count	8 Count
1770215190	7 Count	22 Count	6 Count
1770213388	3 Count	12 Count	3 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)