PenangAPRS Track

My position About ☰

reset

SP2AJ-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP2AJ-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1794357200	647 Count	1001 Count	543 Count
1794356299	640 Count	991 Count	537 Count
1794355398	635 Count	983 Count	533 Count
1794354497	628 Count	974 Count	527 Count
1794353596	623 Count	965 Count	523 Count
1794352696	616 Count	955 Count	517 Count
1794351795	611 Count	947 Count	513 Count
1794350894	601 Count	934 Count	504 Count
1794349993	596 Count	926 Count	500 Count
1794349093	590 Count	916 Count	495 Count
1794348192	586 Count	909 Count	492 Count
1794347291	580 Count	902 Count	487 Count
1794346408	576 Count	897 Count	484 Count
1794345507	571 Count	889 Count	480 Count
1794344607	567 Count	882 Count	477 Count
1794343706	562 Count	876 Count	473 Count
1794342805	558 Count	871 Count	470 Count
1794341904	553 Count	863 Count	466 Count
1794341004	550 Count	858 Count	464 Count
1794340103	545 Count	851 Count	460 Count
1794339202	541 Count	845 Count	457 Count
1794338302	536 Count	838 Count	453 Count
1794337401	532 Count	831 Count	450 Count
1794336500	526 Count	825 Count	445 Count
1794335599	523 Count	820 Count	443 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)