PenangAPRS Track

My position About ☰

reset

F4GCF-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object F4GCF-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	RX*	Digi*
1786415612	910 Count	399 Count
1786415012	888 Count	392 Count
1786414412	870 Count	385 Count
1786413812	852 Count	375 Count
1786413212	826 Count	364 Count
1786412612	807 Count	358 Count
1786412011	792 Count	351 Count
1786411411	767 Count	342 Count
1786410811	752 Count	337 Count
1786410211	734 Count	330 Count
1786409611	716 Count	322 Count
1786409011	699 Count	316 Count
1786408411	683 Count	310 Count
1786407811	667 Count	304 Count
1786407211	655 Count	299 Count
1786406611	643 Count	294 Count
1786406010	630 Count	288 Count
1786405411	615 Count	284 Count
1786404810	605 Count	280 Count
1786404210	594 Count	274 Count
1786403610	582 Count	269 Count
1786403010	565 Count	263 Count
1786402409	552 Count	257 Count
1786401809	539 Count	251 Count
1786401209	528 Count	247 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)