PenangAPRS Track

My position About ☰

reset

SR2CSR-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SR2CSR-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1794347557	92 Count	907 Count	64 Count
1794344856	88 Count	878 Count	61 Count
1794342157	85 Count	845 Count	59 Count
1794339456	83 Count	806 Count	58 Count
1794336755	79 Count	770 Count	55 Count
1794334054	75 Count	718 Count	52 Count
1794331354	70 Count	683 Count	48 Count
1794328658	62 Count	642 Count	45 Count
1794325958	58 Count	612 Count	42 Count
1794323257	55 Count	573 Count	40 Count
1794320556	51 Count	533 Count	37 Count
1794317855	48 Count	496 Count	35 Count
1794315154	44 Count	457 Count	32 Count
1794312453	38 Count	399 Count	27 Count
1794307057	24 Count	283 Count	19 Count
1794304356	18 Count	239 Count	14 Count
1794301656	14 Count	193 Count	11 Count
1794298954	10 Count	156 Count	8 Count
1794296254	7 Count	107 Count	6 Count
1794293553	3 Count	61 Count	3 Count
1794290853	99 Count	1039 Count	68 Count
1794288152	94 Count	989 Count	64 Count
1794285456	86 Count	941 Count	61 Count
1794282755	82 Count	903 Count	58 Count
1794280054	79 Count	855 Count	56 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)