PenangAPRS Track

My position About ☰

reset

SP9EPW-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP9EPW-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

Time	TX*	RX*	Digi*
1786522548	85 Count	279 Count	28 Count
1786520747	84 Count	274 Count	28 Count
1786518946	83 Count	270 Count	28 Count
1786517145	82 Count	266 Count	28 Count
1786515344	81 Count	259 Count	28 Count
1786513544	80 Count	255 Count	28 Count
1786511743	79 Count	249 Count	28 Count
1786509942	78 Count	242 Count	28 Count
1786508141	77 Count	228 Count	28 Count
1786506340	76 Count	223 Count	28 Count
1786504548	71 Count	216 Count	28 Count
1786502748	70 Count	211 Count	28 Count
1786500946	69 Count	206 Count	28 Count
1786499146	68 Count	200 Count	28 Count
1786497345	67 Count	197 Count	28 Count
1786495544	66 Count	194 Count	28 Count
1786493743	65 Count	187 Count	28 Count
1786491943	64 Count	183 Count	28 Count
1786490142	63 Count	179 Count	28 Count
1786488341	62 Count	175 Count	28 Count
1786482947	55 Count	159 Count	28 Count
1786479346	53 Count	151 Count	28 Count
1786477545	52 Count	148 Count	28 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)