PenangAPRS Track

My position About ☰

reset

SN9GK-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SN9GK-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1794339110	8 Count	1031 Count
1794337309	7 Count	916 Count
1794335508	6 Count	805 Count
1794333707	5 Count	702 Count
1794331906	4 Count	568 Count
1794330106	3 Count	458 Count
1794328314	2 Count	333 Count
1794326513	1 Count	205 Count
1794324712	0 Count	102 Count
1794322911	9 Count	1098 Count
1794321111	8 Count	990 Count
1794319310	7 Count	870 Count
1794317509	6 Count	761 Count
1794315708	5 Count	631 Count
1794313907	4 Count	529 Count
1794312107	3 Count	431 Count
1794310306	2 Count	332 Count
1794308505	1 Count	211 Count
1794306714	0 Count	112 Count
1794304913	8 Count	1042 Count
1794303112	7 Count	940 Count
1794301312	6 Count	831 Count
1794299511	5 Count	721 Count
1794297710	4 Count	598 Count
1794295909	3 Count	492 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)