PenangAPRS Track

My position About ☰

reset

SP3KAU-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP3KAU-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1794371994	131 Count	760 Count	92 Count
1794370193	125 Count	744 Count	87 Count
1794368391	119 Count	728 Count	82 Count
1794366593	115 Count	716 Count	79 Count
1794364789	110 Count	701 Count	75 Count
1794362988	105 Count	687 Count	71 Count
1794361186	100 Count	673 Count	67 Count
1794359385	96 Count	665 Count	64 Count
1794357598	92 Count	654 Count	61 Count
1794355797	88 Count	644 Count	58 Count
1794353996	85 Count	631 Count	56 Count
1794352194	82 Count	621 Count	54 Count
1794350393	78 Count	609 Count	51 Count
1794348591	75 Count	579 Count	49 Count
1794346790	70 Count	558 Count	45 Count
1794344989	67 Count	521 Count	43 Count
1794343188	63 Count	487 Count	40 Count
1794341386	54 Count	457 Count	38 Count
1794339585	48 Count	430 Count	34 Count
1794337783	45 Count	412 Count	32 Count
1794336000	39 Count	379 Count	29 Count
1794334198	33 Count	344 Count	27 Count
1794332396	27 Count	271 Count	22 Count
1794330593	15 Count	181 Count	11 Count
1794328792	2 Count	80 Count	2 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)