PenangAPRS Track

My position About ☰

reset

SP3HUO-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP3HUO-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1790363550	721 Count	268 Count	123 Count
1790361749	714 Count	268 Count	123 Count
1790359948	710 Count	268 Count	123 Count
1790358146	708 Count	268 Count	123 Count
1790356345	705 Count	268 Count	123 Count
1790354544	703 Count	268 Count	123 Count
1790352743	697 Count	268 Count	123 Count
1790350942	695 Count	268 Count	123 Count
1790349141	693 Count	268 Count	123 Count
1790347339	691 Count	268 Count	123 Count
1790345537	689 Count	268 Count	123 Count
1790343736	677 Count	268 Count	123 Count
1790341962	662 Count	255 Count	110 Count
1790340160	657 Count	253 Count	108 Count
1790338359	652 Count	251 Count	106 Count
1790336558	648 Count	249 Count	104 Count
1790334757	644 Count	247 Count	102 Count
1790332955	628 Count	245 Count	100 Count
1790331154	624 Count	243 Count	98 Count
1790329353	620 Count	241 Count	96 Count
1790327552	616 Count	239 Count	94 Count
1790325751	612 Count	237 Count	92 Count
1790323950	608 Count	235 Count	90 Count
1790322149	599 Count	233 Count	88 Count
1790320348	589 Count	231 Count	86 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)