PenangAPRS Track

My position About ☰

reset

SP2SGL-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP2SGL-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1766076447	555 Count	614 Count	514 Count
1766074646	540 Count	600 Count	500 Count
1766072846	518 Count	578 Count	479 Count
1766071045	504 Count	565 Count	466 Count
1766069249	488 Count	549 Count	451 Count
1766067449	473 Count	533 Count	437 Count
1766065648	457 Count	518 Count	422 Count
1766063847	439 Count	500 Count	405 Count
1766062046	420 Count	480 Count	387 Count
1766060246	408 Count	468 Count	376 Count
1766058445	394 Count	455 Count	363 Count
1766056644	379 Count	441 Count	349 Count
1766054843	364 Count	426 Count	335 Count
1766053043	347 Count	410 Count	319 Count
1766051242	336 Count	400 Count	309 Count
1766049441	325 Count	390 Count	299 Count
1766037210	229 Count	295 Count	217 Count
1766035408	213 Count	274 Count	202 Count
1766033607	192 Count	248 Count	182 Count
1766031806	170 Count	221 Count	161 Count
1766030005	143 Count	185 Count	135 Count
1766028204	115 Count	149 Count	108 Count
1766026412	82 Count	109 Count	80 Count
1766024611	55 Count	75 Count	54 Count
1766022810	24 Count	36 Count	24 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)