PenangAPRS Track

My position About ☰

reset

SP7TBU-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP7TBU-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 >>

Time	TX*	RX*	Digi*
1794344321	124 Count	616 Count	96 Count
1794343120	113 Count	572 Count	87 Count
1794341939	102 Count	509 Count	77 Count
1794340738	91 Count	466 Count	70 Count
1794339537	78 Count	415 Count	61 Count
1794338336	69 Count	361 Count	53 Count
1794337135	61 Count	312 Count	47 Count
1794335934	48 Count	265 Count	39 Count
1794334732	38 Count	195 Count	30 Count
1794333531	27 Count	140 Count	22 Count
1794332330	11 Count	56 Count	10 Count
1794331129	182 Count	1013 Count	136 Count
1794329928	174 Count	946 Count	130 Count
1794328727	164 Count	886 Count	122 Count
1794327526	151 Count	836 Count	113 Count
1794326325	138 Count	759 Count	102 Count
1794325124	127 Count	706 Count	93 Count
1794323923	114 Count	635 Count	84 Count
1794322723	104 Count	582 Count	77 Count
1794321522	95 Count	528 Count	70 Count
1794320340	86 Count	477 Count	64 Count
1794319138	77 Count	435 Count	58 Count
1794317937	67 Count	387 Count	50 Count
1794316735	58 Count	308 Count	42 Count
1794315535	45 Count	236 Count	34 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)