PenangAPRS Track

My position About ☰

reset

SP9BOT-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP9BOT-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1794363005	55 Count	831 Count	18 Count
1794362404	54 Count	808 Count	18 Count
1794361803	51 Count	791 Count	16 Count
1794361202	50 Count	770 Count	16 Count
1794360601	49 Count	748 Count	16 Count
1794360000	47 Count	726 Count	15 Count
1794359400	46 Count	705 Count	15 Count
1794358799	45 Count	682 Count	15 Count
1794358198	43 Count	659 Count	14 Count
1794357597	42 Count	641 Count	14 Count
1794356996	41 Count	624 Count	14 Count
1794356396	39 Count	604 Count	13 Count
1794355795	38 Count	581 Count	13 Count
1794355194	37 Count	564 Count	13 Count
1794354593	35 Count	539 Count	12 Count
1794353993	34 Count	519 Count	12 Count
1794353392	33 Count	503 Count	12 Count
1794352791	31 Count	483 Count	11 Count
1794352190	30 Count	454 Count	11 Count
1794351589	28 Count	435 Count	10 Count
1794350989	26 Count	413 Count	9 Count
1794350388	25 Count	394 Count	9 Count
1794349787	24 Count	362 Count	9 Count
1794349186	22 Count	316 Count	8 Count
1794348586	21 Count	284 Count	8 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)