PenangAPRS Track

My position About ☰

reset

F4MLV-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object F4MLV-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

Time	TX*	RX*	Digi*
1773959127	355 Count	574 Count	291 Count
1773957323	312 Count	505 Count	255 Count
1773955518	278 Count	441 Count	228 Count
1773953715	241 Count	379 Count	198 Count
1773951911	199 Count	312 Count	164 Count
1773950107	158 Count	243 Count	130 Count
1773948304	119 Count	186 Count	98 Count
1773946500	77 Count	119 Count	63 Count
1773944696	41 Count	58 Count	34 Count
1773942892	718 Count	1056 Count	621 Count
1773941089	671 Count	988 Count	581 Count
1773939330	614 Count	919 Count	531 Count
1773937527	557 Count	857 Count	481 Count
1773935723	516 Count	797 Count	447 Count
1773933919	478 Count	741 Count	416 Count
1773932115	435 Count	683 Count	380 Count
1773930312	398 Count	632 Count	350 Count
1773928508	362 Count	574 Count	321 Count
1773926700	290 Count	482 Count	257 Count
1773924897	240 Count	382 Count	214 Count
1773923093	198 Count	315 Count	179 Count
1773921289	158 Count	260 Count	146 Count
1773919486	119 Count	207 Count	115 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)