PenangAPRS Track

My position About ☰

reset

UN9GIE-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object UN9GIE-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*
1782539861	385 Count	955 Count
1782539258	384 Count	953 Count
1782538654	383 Count	951 Count
1782538051	382 Count	950 Count
1782537448	381 Count	948 Count
1782536844	380 Count	946 Count
1782536240	379 Count	946 Count
1782535636	378 Count	945 Count
1782535032	377 Count	943 Count
1782534429	376 Count	942 Count
1782533825	375 Count	940 Count
1782533222	374 Count	938 Count
1782532618	373 Count	937 Count
1782532015	372 Count	935 Count
1782531412	371 Count	933 Count
1782530808	370 Count	932 Count
1782530204	369 Count	931 Count
1782529601	368 Count	930 Count
1782528998	367 Count	929 Count
1782528394	366 Count	928 Count
1782527790	365 Count	926 Count
1782527187	364 Count	925 Count
1782526583	363 Count	923 Count
1782525980	362 Count	921 Count
1782525376	361 Count	920 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)